TERMA MEG Gebrauchsanweisung Seite 25

Anti-freeze function
When the device is off and the temperature
surrounding the temperature sensor drops
to below 6° C, the device will switch on au-
tomatically. This is to prevent the heating
agent inside the radiator from freezing. The
activation of Anti-freeze mode is indicated
by the blinking of the middle diode.
Dryer function
The Dryer turns the device on for 2 hours,
e.g. in order to dry a towel. After this peri-
od of time the device automatically switch-
es to the mode to which it was set before
the dryer mode.
Dryer function can be activated during
heater operation by pressing and holding
button. You can now freely adjust desired
temperature level (buttons
2 hrs heater will revert to the previous set-
ting (before dryer function activation).
To use 2 hrs timer heating element must be
switched off. Switch it on by pressing and
holding button. After 2 hrs heater will
switch off automatically.
Press button at any time to interrupt the
dryer mode.
EN
Remote control mode (wireless
communication)
If the device is located in a room with an
external IR controller suitable for commu-
nication with the heater, the first signal
received by the heater will automatically
switch it to reception mode. The device will
heat with the temperature indicated by the
external controller while continuing to lim-
it the radiator temperature not to exceed
60°C. Remote control mode is indicated by
the middle diode. In case of communica-
tion loss for longer than 25 minutes, the
device will automatically switch to manual
mode, continuing to operate at the last set-
ting. Any new signal received by the heat-
er, will switch it back to the remote con-
trol mode.
Dryer function can be activated in re-
mote control mode (when the dryer func-
tion is deactivated, the heater will go back
and ). After
to reception of signals from the external
controller).
Calibrating the temperature span
same as MOA
Problem solving
same as MOA
25