TERMA MEG Gebrauchsanweisung Seite 18

will light up diodes on the heating time in-
dicator and allow the user to preset the
"switch off" time of the device to between
1 and 5 hours from the current time.
After this time, the heater will turn off
automatically.
It is useful to know that:
• Longer pressing of the button will au-
tomatically set the timer to 5 hours or,
turn off the TIMER function,
• The button can also be used when
the heater is off. On pressing the but-
ton, the heater will automatically turn
on and set the TIMER to 1 hour,
• If you want to turn the TIMER off, press
the button several times or simply
turn the heater off and on,
• TIMER LED diodes will turn off one by
one, to display the correct, remaining
drying time.
The construction of the heater as well as
physical characteristics of various heating
liquids may cause an uneven heat distribu-
tion inside the towel rail. As a result, bot-
tom pipes of the towel rail may stay cool.
Such phenomenon is completely normal
and is not an indication of heater failure.
18
User manual MEG, DRY, MOA, REG 2, REG 3 www.termaheat.pl
Modification of radiator heating
temperature
The default temperature of the heater is
48° C. The user can modify the heating tem-
perature by following these steps:
1. Disconnect the device from the elec-
tricity supply (i.e. unplug the device).
2. Press and hold the on/off button while
reconnecting the heater to the electric-
ity supply.
3. Release the button.
4. One of 5 TIMER diodes will start flash-
ing. Select the required temperature
value by pressing the button until the
corresponding diode starts flashing.
Temperature values for each diode are
shown in the table below:
52°
5. Wait for 10 seconds or press the TIMER
button in order to confirm your chosen
value.