Multi-Protocol Operation; Digital Operation - Märklin 60947 Bedienungsanleitung

Insert the plug into the connector while paying attention to
the positioning. Place the model, with the body left off, on
the programming track and test it. If the decoder works with
no problems, the body can be put on the locomotive.
Cross Referencing the Colors for the Wires
Description
Motor Connection 2
Conductor Current Pickup, Track, Left
(DC) Outer (AC)
Front Lights
Function 1
Common Wire for Lights
Rear Lights
Conductor Current Pickup,
Track, Right (DC) Center (AC)
Motor Connection 1
Speaker +
Speaker –
Aux 2 (physical output)
Aux 3 (physical output)
Aux 4 (physical output)
28
Wire Color
NEM Märklin
gray blue
black brown
white gray
green brown/red
blue orange
yellow yellow
red red
orange green
brown white
brown white
violet brown/green
brown/yellow
brown/white

Multi-Protocol Operation

Analog Operation
This decoder can also be operated on analog layouts or
areas of track that are analog. The decoder recognizes
alternating current or direct current voltage (AC/DC) and
automatically adapts to the analog track voltage. All func-
tions that were set under mfx or DCC for analog operation
are active (see Digital Operation).

Digital Operation

The mSD sound decoders are multi-protocol decoders.
These decoders can be used under the following digital
protocols: mfx, DCC, fx (MM).
The digital protocol with the most possibilities is the highest
order digital protocol. The sequence of digital protocols in
descending order is:
Priority 1: mfx
Priority 2: DCC
Priority 3: fx (MM)
Note: Digital protocols can influence each other. For trouble-
free operation, we recommend deactivating those digital
protocols not needed by using CV 50. Deactivate unneeded
digital protocols at this CV if your controller supports this
function.
If two or more digital protocols are recognized in the track,
the decoder automatically takes on the highest order digital
protocol, example: mfx/DCC; the decoder takes on the mfx
digital protocol (see previous table).