Operation With Mfx - Märklin 74466 Installation

DCC
CV Meaning
1 Address, lower value Byte 0-255 (1)
7 Manufacturer version
number (software
version)
8 Manufacture recognition
ID Decoder reset
9 Address, higher value Byte 0-7
29 Configuration
Bits 0-4 are not used
Bit 5: Decoder type
Bit 6: Addressing method
Bit 7: Decoder type
34 Three-way turnout
36 Turnout lantern, off/on
Setting and generating addresses larger than 255:
Example: Address 1044 -> 1044:256=4,078125. The value before
the comma (4) is to be entered in CV 9. The value after the
comma (0,078125) is multiplied by 256, 078125x256=20. The value
of 20 that is generated must be entered in CV 1.
Values
(-) read only
(131) read only,
8 (-) factory setting, value
is not written
(0)
(192) read only
0
0 / 32 basic or advanced
accessory decoder
decoder or output
0 / 64
address
128 accessory decoder
0-1 (1) Setting for the
Central Station 2 and
Central Station 3
always 0
Setting for other
controllers always 1
0-1 (1)

Operation with mfx

mfx registration can be done with MM or DCC.The mode of ope-
ration that has been set by means of Dip Switch 10 is critical.
The mfx registration is initiated with the 60213/60214/60215 CS2
in > and with the 60216/60226 CS3 in the solenoid item
configuration by means of
Note about mfx registration with the CS2:
Selection possibility „Automatically assign solenoid item" at
„Setup" > > „Track".
If the check mark there is checked, the mfx registration is done
at the first open address in the CS2. If the check mark is not
checked, the mfx registration is done at the address actually
programmed on the decoder.
>"search for mfx item".
9