Operation With Mm (Motorola); Advanced Functions; Parameters / Cvs For Mm - Märklin 60832 Bedienungsanleitung

Operation with MM (Motorola)

Dip switch 10 must be set at "OFF" for operation of the m83
with MM.
The turnouts connected to the m83 can now be addressed
and activated with the addresses previously set. The moni-
tor lights on the decoder will display the switched status of
the turnouts (green / red).

Advanced Functions

Programming can be used to set additional functions on
the m83 turnout decoder.
These programming parameters must be done at the
programming track. Different parameters can be set using
address 80. The two corresponding monitor lights will blink
as a check feature during the data transfer.
The turnout to be programmed must be switched with the
Keyboard before the programming. After that, change the
parameters immediately with the Control Unit or with the
CV configuration on the Central Station. After you have
completed the programming process, immediately switch
the programmed turnout again with the Keyboard. The
programming has not been accepted and is not effective
until now.
The procedure for programming with the 6021 Control Unit is
analogous to the programming for locomotives
(www.maerklin.de -> Tools & Downloads -> Technische
Informationen).
18

Parameters / CVs for MM

CV Description
8 Reset
Automatic turnout circuit output 1&2
2 x two-way turnout
34
Three-way turnout
Double slip switch
Automatic turnout circuit output 3&4
2 x two-way turnout
35
Three-way turnout
Double slip switch
Preset Operating Mode
79
(See Page 20)
The function "Automatic Turnout Circuit" can be used to link
2 outputs on the decoder together and switch them together
for a three-way turnout or a double slip switch.
Additional settings are possible with DCC, and these settings
also influence operation with MM.
The 60821 control electronic circuit is also required for
control of a motor.
Value
8
0
1
2
0
1
2
0 – 5