Troubleshooting - Klarstein 10033000 Bedienungsanleitung

EN
28
Notes on the Weekly Timer
• The room temperature and the switch-on/switch-off time can be set individually for
each day.
• Repeat the steps described above to set the room temperature, switch-on and
switch-off times for further days.
• If you select[ALL], the selected setting is the same for all days.
• If the heating is running, the set switch-on time is ignored, while the set switch-off
time is observed by the device.
• If a manual timer is also set up when the week timer is active, the device depends
on the timer whose time runs out first.
• If the selected Adaptive Start temperature is lower than the temperature entered for
the week timer, the heating is not switched on.
• While the week timer is being set, the[DATE] display is on all the time.
Note: Press and hold the SET UP button for three seconds to clear all settings.

TROUBLESHOOTING

Problem
The fireplace won't start.
The fireplace switches off
automatically.
The remote control does
not work.
The flame effect does not
work properly.
The fireplace does not
generate heat.
Possible Cause
The cable is loose.
The Adaptive Start
function or the weekly
timer is active.
Batteries too low.
The flame effect does not
work properly.
The device is broken.
The room temperature is
higher than the set value.
Suggested Solution
Plug the cable firmly into
the device.
Check the settings and
correct them if necessary.
Change the batteries.
Reduce the distance
between the fireplace and
the remote control.
Contact a specialist
company for inspection
and repair.
Check the settings.