Cleaning And Maintenance; Troubleshooting - Klarstein 10030845 Bedienungsanleitung

CLEANING AND MAINTENANCE

Note: always disconnect the appliance at the supply outlet socket before undertaking any cleaning.
• Except for periodic cleaning of dust, there are no specific requirements for care, other than regular cleaning of the
general appliance. A wipe with a dry cloth is normally sufficient. DO NOT use abrasive cleaners as they can damage
the finish.
• Make sure the heater outlet grille (located next to the switches) are kept clear of dust, pet hair and other airborne
household matter. These should be vacuum cleaned periodically using a brush attachment.
• If in doubt consult a qualified electrician.
• Excluding fuses, use only genuine manufacturers spare parts available from your supplier.
Important information on maintenance and repairs
• The device has a special fuse. If the fuse has to be replaced, have it replaced by a specialist company with a fuse of
the same type.
• This product has no user-serviceable parts. Do not attempt to repair this product yourself. Only qualified service
personnel should perform servicing!

TROUBLESHOOTING

Problem
Fire is not switching on.
Logs glow but flame effect
does not work.
Heater doesn't work, but
Power and Heater switches
/ buttons are in the „ON"
position
Fire seems noisy.
Remote is not operating
Display shows E1.
Display shows E2.
Possible Cause and Suggested Solution
Ensure mains switch is on.
Replace the fuse in the plug.
Check to see if the spinning motor is working.
Turn all switches / buttons to the „OFF" position and
unplug the unit from the wall outlet for 10 minutes. After
10 minutes plug the unit back into wall outlet, and
operate as normally.
There is a level of noise when the flame effect is in use,
caused by a motor that helps generate the effect. This
noise will be heard when there is no other background
noise.
There is a higher level of noise associated with the heater
motor; this is due to the air flow required when heat has
been selected.
Check or replace batteries.
The overheating protection has been triggered.
The thermostat sensor is defective or disconnected.
24