Servicing/Cleaning; Laying Up The Vehicle; Warranty - Vari FM33 Originalbetriebsanleitung

Transporting
appliance
!
Danger
Before transporting the unit on or
in a vehicle: Switch off motor and
remove connection cable.
Leave motor to cool
(approx. 30 minutes).
transport on or in a vehicle,
secure the appliance adequately
against slipping.
Before lifting or carrying the unit,
pull out the mains plug. Before
moving the unit over surfaces,
such as footpaths or driveways,
stop the motor.
Caution
Do not wedge or kink the cable
which runs between the motor
and switch/plug combination.
Figure 6
• The steering handle can be
folded down to facilitate storage.

Servicing/cleaning

!
Danger
To protect against injury before
all
work on the appliance
— switch 0FF the engine,
— wait until all rotating parts have
come to a standstill,
— pull out the mains plug,
— leave motor to cool down
(approx. 30 minutes).
Servicing
!
Danger
To protect against injury from (the
cutters, have a specialist garage
perform all work
replacing or regrinding the cutters
(special tools required).
Before each operation
• Check connection cable.
• Check that
connections are tight.
• Check safety devices.
• Check unit - see section "Before
working with the appliance".
Check the point of contact of the
clutch:
the (only in the case of awn mowers
with gear drives)
— The lawn mower should not
drive forwards when the engine is
running and when the gear drive
is not engaged.
— The awn mower should drive
forwards when the engine is
down
running and the gear drive is
For
engaged.
• If necessary, adjust the point of
connection using the knurling
tool/adjusting nut on the gear
drive lever or Bowden cable.
Once a season
• Lubricate the joints and torsion
spring on the discharge flap.
• Al the end of the season the
appliance must be checked and
serviced at a specialist garage.
Cleaning
Caution
Do not splash the unit with
—
water,
components may be damaged.
— Clean the appliance after every
use. Failure
appliance
materials
malfunctions.
Cleaning the grass sack
The easiest time to dean the
grass
catcher
mowing.
• Detach and empty the grass
sack.
— The grass sack can be cleaned
by means of a powerful jet of
water from a garden hose.
• Allow the grass sack to dry out
such as
thoroughly before using it again.
Cleaning Iawnmower
!
Danger
Work on the cutters can cause
injury. Wear safety gloves for
your protection.
threaded
possible,
appliance directly after mowing.
• Tilt the unit 10 the side,
• clean the cutter chamber and
the ejector cover with brush,
hand broom, or cloth,
• set the appliance down on its
wheels and remove all visible
grass residue and other soiling.
otherwise electric
to clean the
can damage the
and cause
is immediately after
Whenever
always clean the
5

Laying up the vehicle

Caution
Damage to mower materials
Keep the vehicle only in clean
and dry rooms when the engine
is cold. During prolonged storage,
e.g. in winter, ensure that the unit
is protected against rust.
At the end of the season or when
the vehicle will not be used for
longer than a month,
• Clean the appliance and the
grass sack.
• To protect metal parts from rust,
wipe them all down with an oiled
cloth (resin-free oil) or apply an
oil spray.

Warranty

The warranty rules issued by our
company or the importer apply to
every country. As part of the
warranty, we
malfunctions on your appliance
free of charge provided that this
malfunction is caused
material or manufacturing defect.
In the event of a warranty claim,
please turn to your dealer or the
nearest branch office.
remedy
by a