Mains Connection; Operation - Parkside PHD 110 A1 Originalbetriebsanleitung

• Remove the nozzle cleaning pin
(6) from the rear fold-out side of
the guidance and slide it into the
receptor on the holder for the
spray gun (5).
• Screw the equipment side of the
high-pressure hose connection
(1) to the high-pressure hose con-
nection (7) on the equipment.
• Insert the high-pressure connec-
tion on the gun side (18) into the
spray gun (14).
• Establish the water supply by
connecting the rapid-action wa-
ter supply connector to the water
connection with sieve insert
A
( 10).
• Connect to the spray gun (4) by
C
inserting and screwing in the jet
tube (2).
• If the jet pipe (2) is fitted, screw
in with the jet pipe (2) to connect
either the adjustable fan nozzle
(11) or the high pressure nozzle
(12).
• Screw in to connect the deter-
gent container with nozzle (
15) directly to the spray gun (4).
With using the cleaning agent
container with the nozzle (
15), pour only cleaning agent
into the container. It is sucked in
automatically.
The width of the jet can be increased by
turning the end of the nozzle to the left. To
reduce the width of the jet, turn the end of
the nozzle to the right.

Mains connection

The pressure washer you have acquired is
already fitted with a mains plug. The pres-
sure washer must only be connected to an
earthed socket 230 V ~ 50 Hz.
Only operate the pressure washer
after all the above points have been
observed.
• Ensure that the pressure washer is
turned off by its ON/OFF switch (
17).
• Insert the mains plug into the mains
socket

Operation

• Connect the equipment to the water
tap. Observe the regulations for the
use of a system separator.
• Turn on the water tap entirely.
Never operate the pressure washer
with a closed water tap. Dry run-
ning will damage the washer!
A
Be prepared for the recoil
force of the emitted water jet!
Ensure that you are standing
A
firmly and that you are hold-
ing the gun (
otherwise you could injure
yourself or other people.
• Switch on the pressure washer with the
ON/OFF switch (
• Pull the lever of the gun (
on the washer.
A 4) securely,
A
17).
Releasing the lever will switch
off the washer, but the pressure
within the system is retained.
GB IE
A
A
4) to turn
23