Herunterladen Inhalt Inhalt Diese Seite drucken

Camera Control On Multi-Copter(Single Mode) - YUNEEC PROACTION CGO4 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Choose the right codes and press Bind.
STEP 7: If it is the first time to bind your CGO4 to the ST24, you need to insert the password:
1234567890. Press OK on the pop-up window to continue.
STEP 8: Press Camera Select and choose CGO4. Press Select, then press OK.
NOTICE: We recommend users to power on the aircraft in the angle mode.
NOTICE: When returns back to the FPV interface, you will hear two long beeps. That means
the binding is complete. The Real-time images can now be seen on the screen.
CAMERA CONTROL ON MULTICOPTRER (SINGLE MODE)
CAUTION: The gimbal can only be controlled through ST24 When being attached to H920.
Gimbal Pitch Control
Gimbal Pitch Control
There is a gimbal pitch mode switch on ST24---S1. When the switch is in up/middle position,
the CGO4 gimbal camera is in Angle Mode. Use the slider on the left side of the ST24 to set
the pitch/tilt position of the gimbal camera. When the S1 is in bottom position, the gimbal
camera is in Velocity Mode. When the slider is in the middle position, it means the velocity
rate is 0 for the CGO4 gimbal camera, and it will stop pitching up/down. When the slider is
above the middle position, the CGO4 will start pitching up. When the slider is below the
middle position, the CGO4 will start pitching down. The distance between the slider and the
middle position decides the velocity rate, the further distance, the higher velocity it would be.
Button A = Take Still Photo
Button B = Start/Stop Recording Video
Gimbal Yaw Control
There is a gimbal yaw mode switch on ST24---S2.
When the switch position is up and middle, the
gimbal camera is in Follow Mode. The yaw control of
the gimbal camera is now disabled. The gimbal
camera will adjust its yaw direction according to the
aircraft's movements. When the switch position is
down, the gimbal camera is in Global Mode. The
Gimbal Yaw control knob (K1) is now activated.
When the user rotates the knob in the right direction,
the gimbal camera will rotate to the right side, and
vice versa.
6

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis