ENGLISH
Problem
Temperature cannot be set.
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If your appliance still is not
working properly making the
above checks, contact the
Authorised Service Centre. You
can find the list at the end of this
manual.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
the assembly instructions.
Possible cause
The FastFreeze function is
switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
The door has been
opened often.
The FastFreeze function is
switched on.
There is no cold air circula-
tion in the appliance.
3. If necessary, replace the defective door
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Switch off FastFreeze manual-
ly, or wait until the function re-
sets automatically to set the
temperature. Refer to "Fast-
Freeze function".
Keep the Mode pressed for
approximately 10 seconds un-
til a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Open the door only if necessa-
ry.
Refer to "FastFreeze function".
Make sure that there is cold
air circulation in the appliance.
gaskets. Contact the Authorised Service
Centre.
17
Solution