Function Settings On The Electronics Module - WimTec ECOSAN W6 Montage- Und Bedienungsanleitung

EN
ECOSAN W6

Function settings on the electronics module

1
4
1
2
!
Note:
If adjustments are made to the
electronic module after initial
start-up, it is recommended
to activate the cleaning stop
beforehand (see page 34)�
30 Washbasin fitting
2
2
5
1.
Loosen locking screw on the underside of the sensor hood
using the Allen key (size 2) provided (3 rotations)�
2. Rotate hood anticlockwise and remove to the side�
3. Remove the electronics module from the sensor hood and
make the desired settings (see page 27)�
4.
Insert the electronics module into the sensor hood�
Position sensor hood (sensor window gently tilted
upwards) and rotate clockwise until the stop�
5. Then tighten the locking screw by hand�
WimTec ECOSAN W6
3
1