Assembly & Start-Up - WimTec ECOSAN W6 Montage- Und Bedienungsanleitung

ECOSAN W6
Assembly | start-up
7
10
3 s |
7.
Attach the fi tting and securely fasten with S-connections
(size 30)�
8.
If necessary, make settings on the electronic module� Open the
sensor hood, see page 30
9. When using the device for the fi rst time, hold the magnetic pen
5 s to the symbol on the side� Commissioning is confi rmed by
fl ashing for 5 times of the control LED�
10.
After the solenoid valve detection, an automatic range adjust-
ment in order to optimally adjust the response range to the
mounting situation is done� The user may not be in the opera-
ting range of the fi tting� The control LED fl ashes after about 3 s
for 3 times and the fi tting is ready for operation�
11.
Open water supply and perform functional test�
8
11
3 x
9
see p. 30
WimTec ECOSAN W6
Washbasin fi tting
EN
5 s | 5 x
ATTENTION!
Perform the following
steps in the order
indicated!
29
!