WimTec ECOSAN W6 Montage- Und Bedienungsanleitung Seite 28

EN
ECOSAN W6
Assembly
1
4
!
ATTENTION!
Perform the following
steps in the order
indicated!
28 Washbasin fi tting
2
5
30 s
1.
Close the main water valve�
2. Attach the two S-connections and screw into the warm and
PWC line� Observe assembly dimension of 34 mm!
3. Set the centre line length of S-connections to 150 mm and
ensure it is horizontally aligned�
4. Where necessary, seal off space between wall and S-connec-
tion with silicone�
5. Open the main water valve pre-fl ush PWC and PWH line for
min� 30 s� Then close the main water valve again�
6. Position the cover rosette on both water connections
WimTec ECOSAN W6
3
6