Daikin RoCon+ HP Betriebsanleitung Seite 524

9 Směšovací modul
Nabídka: Access
Nabídka: System
Min. mixer valve pump System
Max. mixer valve pump
Obr. 97-6 Parametry v nabídce "System"
Nabídka: Sensors
Outside temperature sensor
Outside temperature correction
Obr. 97-7 Parametry v nabídce "Sensors"
Nabídka: HC config
Weather-compensated
Frost protection temperature
Building insulation
Obr. 97-8 Parametry v nabídce "HC config"
Nabídka: Heating
Heating limit, heating mode
Heating limit, reducing mode
Heating curve
Feed temperature, heating mode
Feed temperature, reducing mode
Max. feed temperature
Min. feed temperature
Room influence
Room sensor adaptation
Heating curve adaptation
Slope offset
Obr. 97-9 Parametry v nabídce "Heating"
Nabídka: Cooling
Cooling curve
Cooling parameters
Obr. 97-10 Parametry v nabídce "Cooling"
Nabídka: Special
Relay test
Screed
Program
Obr. 97-11 Parametry v nabídce "Special"
Návod k provozu
54
Target flow cooling, start
Target flow cooling, max.
Start cooling outside temp.
Max. cooling outside temp.
Feed temperature lower limit
Feed temperature, cooling mode
Cooling setpoint correction
Screed drying
Screed program
Nabídka: Information
Values
Obr. 97-12 Parametry v nabídce "Information"
Average outside temperature
Mixer temperature, current
Mixer temperature, target
Mixer pump status
PWM mixer pump
Mixer valve status
Software no. B1/U1
Mixer software number
Daikin RoCon+ HP
Daikin Regulace RoCon+ HP
008.1444299_01 – 09/2018 – CS