Daikin RoCon+ HP Betriebsanleitung Seite 52

9 Mixer module
Menu: Access
Menu: System
System Min. mixer valve pump
Max. mixer valve pump
Fig. 9-6 Parameter in menu: "System"
Menu: Sensors
Outside temperature sensor
Outside temperature correction
Fig. 9-7 Parameter in menu: "Sensors"
Menu: HC config
Weather-compensated
Frost protection temperature
Building insulation
Fig. 9-8 Parameter in menu: "HC config"
Menu: Heating
Heating limit, heating mode
Heating limit, reducing mode
Heating curve
Feed temperature, heating mode
Feed temperature, reducing mode
Max. feed temperature
Min. feed temperature
Room influence
Room sensor adaptation
Heating curve adaptation
Slope offset
Fig. 9-9 Parameter in menu: "Heating"
Menu: Cooling
Cooling curve
Cooling parameters
Fig. 9-10 Parameter in menu: "Cooling"
Menu: Special
Relay test
Screed
Program
Fig. 9-11 Parameter in menu: "Special"
Operating Instructions
52
Target flow cooling, start
Target flow cooling, max.
Start cooling outside temp.
Max. cooling outside temp.
Feed temperature lower limit
Feed temperature, cooling mode
Cooling setpoint correction
Screed drying
Screed program
Menu: Information
Values
Fig. 9-12 Parameter in menu: "Information"
Average outside temperature
Mixer temperature, current
Mixer temperature, target
Mixer pump status
PWM mixer pump
Mixer valve status
Software no. B1/U1
Mixer software number
Daikin RoCon+ HP
Daikin Controller RoCon+ HP
008.1444299_01 – 09/2018 – EN