Troubleshooting; Spare Parts; Technical Specifications - Kärcher SC 1020 B Bedienungsanleitung

Empty the descaling solution after 8 hours. A
small amount of the solution will remain in
the boiler. Therefore, you should rinse the
boiler two to three times with cold water to re-
move any residues of the descaler.

Troubleshooting

Often, failures have simple causes and you can
do the troubleshooting yourself using the follow-
ing overview. If you are in doubt or if the failure is
not listed here please contact the authorized
customer service.
Danger
Always disconnect the mains plug and allow the
steam ironing station to cool down before per-
forming any maintenance work.
Repair works may only be performed by the au-
thorized customer service.
Long heating-up time
Steam boiler is decalcified.
Descale the steam boiler.
No steam
No water in the steam boiler.
Turn off the appliance.
See"Refilling Water" Page13
After breaks during ironing, water drops will
come out of the steam iron.
During longer breaks from ironing, the steam in
the steam line can condense.
Direct the first burst of steam at a separate
piece of cloth.
Steam iron "spits out" water!
Set the thermostat to level •••.
Rinse or decalcify the steam boiler.
Note:There can be odor during the first applica-
tions. This does not have any affect on the func-
tion of the steam ironing station. The odor will
dissipate with time.

Spare parts

Use only original KÄRCHER spare parts. You
will find a list of spare parts at the end of these
operating instructions.
14
English

Technical specifications

Power connection
Voltage
Protective class
Protection class
Performance data
Heating output
Operating pressure max.
Heating time
per litre of water
Max. steam quantity
Dimensions
Boiler capacity
Weight (without accessories)
Width
Length
Height
Subject to technical modifications!
220-240 V
1~50/60 Hz
I
IPX4
2200 W
0,32 MPa
7 Minutes
65 g/min
1,2 l
3 kg
250 mm
381 mm
260 mm