Hafele DT 100 Montage- Und Bedienungsanleitung Seite 55

Setting up the DT 100 for operation
1. Attach the outside module cover:
Ö Place the lower part of the cover on the bracket in such a way that
the cover's guides sit in the bracket's rails
Ö Press the upper part of the cover backwards onto the bracket until
it snaps in with an audible click. Make sure that the sensitive cable
connectors are not damaged in the process.
2. Use a setscrew (small parts bag).
Place the door lever on the external spindle in such a way that the
setscrew points in the direction of the locking plate.
3. Tighten the setscrew.
4. Insert 4 AA batteries in the battery module of the battery mounting.
Use correct polarity! (See also "Changing the batteries")
5. Attach the inside module cover in the same way as the outside mod-
ule cover.
6. Mount the inside door lever. (As in Steps 2 and 3)
The DT 100 is ready for operation.
Mounting and Operating Instructions
DT 100 - Status: 087.2011 - 732.29.137 55