Hafele DT 100 Montage- Und Bedienungsanleitung Seite 50

Mounting the outside module
a Slot of the spindle socket
Note:
Following the installation of the square socket on the outer module,
the marking (tappet) of the coupling device must always point in
direction R. When inserting into the lock, the square socket must not
be twisted.
1. Thread the connection cable through the drilled hole. Pay attention to
the cable inlet!
2. Place the mounting plate and bracket on the outside door in such a
way that the retaining pins of the mounting plate are located in the
drilled holes in the door, and the spindle socket is sitting in the door
lever socket in such a way that the slot for the setscrew is pointing in
the direction of the strike plate.
3. Ensure that the mounting plate is lying flat on the door.
If the mounting plate is not lying flat:
Ö Check the drilled holes and, if necessary, remove wood shavings.
Use a distance plate if the distance between the outside surface of the
door and the lock chamber is less than 8 mm.
Mounting of the outside module has been completed.
50 DT 100 - Status: 08.2011 - 732.29.137
Mounting and Operating Instructions