Hafele DT 100 Montage- Und Bedienungsanleitung Seite 41

right-facing door leve
Attention!
Ö Do not damage the pin connector when tapping pin in!
3. Using a hammer, lightly tap a 3 x 22 pin into the drilled hole labelled
"R" on the back of the mounting plate. The spring of the door lever is
under pressure.
4. Insert a 4 x 22 pin in the drilled hole labelled "R45°" on the back of the
mounting plate for the door lever limit.
If the door lever angle of rotation is to be greater than 45°:
Ö Insert a 4 x 22 pin in the drilled hole labelled "R80°" on the back of
Ö the mounting plate.
5. Secure the pins with the adhesive labels so that they do not fall out.
Mounting and Operating Instructions
DT 100 - Status: 087.2011 - 732.29.137 41