Operation - Cameo CLZB60BLSD Bedienungsanleitung

OPERATION

PLEASE NOTE:
• When the lamp is correctly connected to the mains supply and the standby switch is in the down position, "Welcome to Cameo", the model
name and the software version are shown on the display consecutively during start-up. After this process, the lamp is ready for operation and
starts in the previously enabled mode.
• If one of the DMX operating modes is activated and there is no DMX signal to the DMX input, the currently programmed DMX address is
displayed and the characters on the display will begin to flash. The flashing stops when a DMX signal is present.
• Following approximately one minute of no input, the display automatically returns to the main display and the currently active mode is
displayed.
• Fast Access Feature: In order to simplify the menu guide, the device has an intelligent menu structure that allows direct access to previously
selected menu items and sub-menu items. 1. Press MODE and ENTER simultaneously for direct access to the last-edited sub-menu item, where
you can make changes instantly as required (DMX starting address and all modes). 2. Press MODE for direct access to the last-selected and
last-edited menu item. Press ENTER repeatedly to access the sub-menu items in order to change individual settings (DMX starting address and
all modes).
• Before changing device settings, ensure that the control panel is dry and dust free, in order not to impair its functionality.
• The display can be rotated through 180° by pressing UP when the main display is visible.
CHARGING THE BATTERY, USING AND STORING THE LIGHT
• The internal battery begins to charge as soon as the light is correctly connected to the mains, so the battery is charged when the light is
in use, too.
• The battery charge status is shown on the display, when the device is switched on and in standby mode.
• The charging time from 0% to 100% charge status is approx. four hours.
• The battery runtime at Full On (RGBW at 100%) is approx. three hours; this is increased significantly if single colours and colour change
programmes are used. The battery runtime can be extended to up to 24 hours by means of the runtime function with reduced brightness.
• After approximately 300 charge cycles (0% - 100%) the battery capacity is approx. 70% of nominal capacity.
• The electronic battery management system protects the battery from overcharge and deep-discharge.
• The battery may only be replaced with an original part at an authorised service centre.
• Do not charge the battery at ambient temperatures of below 0°C and over 40°C. This also means that the battery must be fully charged
(100%) if the light is to be operated on the mains at below 0°C ambient temperature (ambient temperature for operating purposes: -15°C
to 40°C).
• After discharge, fully recharge the battery immediately. Batteries which are not fully recharged lose capacity and service life.
• Store the light with a fully charged battery only.
• If the light is not used over a prolonged period of time, charge the battery fully every six months.
• In order to extend the service life of the battery, we recommend recharging the battery as early as possible; it is also advisable to avoid
using the device for so long that all battery power is used up.
• When used in the cold, the battery runtime may be shorter than expected.
• Store the light in a cool, dry place in order to ensure optimum storage conditions for the battery.
MAIN DISPLAY
After the power-up process, the lamp is ready for operation and starts in the previously activated mode. The main display appears with the
following information: current mode (e.g. DMX mode), W-DMX™ status, battery charge status and mains operation.
W-DMX™ status Battery charge status
Mains operation
DMX Address
001
Current operating mode
7