Battery Runtime; Dimmer Curves - Cameo CLZB60BLSD Bedienungsanleitung

Dimmer Response = Dimmer sensitivity
Color Calibration = Colour calibration
Autolock = Automatic locking of the controls
IR Remote = Activates / deactivates functionality of IR
remote control
Wireless Setting = W-DMX settings
(Wireless-DMX)
Factory Reset = Reset to factory setting
Confirm all entries with ENTER.

BATTERY RUNTIME

The battery runtime can be extended to up to 24 hours by reducing the brightness (see Settings table). Here runtime is calculated based on
Full On and 100% battery charge status. Runtime is significantly extended when not all colours – red, green, blue and white – are activated
(Full On) but only, for example, red.

DIMMER CURVES

linear
DMX value
SYSTEM INFORMATION (System Info)
Press MODE to access the device settings selection menu (--- Menu ---). Using the arrow keys, select the menu item "System Info"
(observe arrow) and confirm with ENTER.
------------------- Menu --------
-----------
Mode
Settings
System Info
Use the UP and DOWN controls to select the desired sub-menu item, and press ENTER to display the corresponding information.
System Info
Firmware = Displays device firmware
Temperature = Displays temperature of LED unit
Operation Hours = Displays operating time
exponential logarithmic
DMX value
DMX value
LED Lamp responds abruptly to changes in
DMX value
Halogen Lamp behaves like a halogen spotlight
with soft brightness changes
Red, Green, Blue, Individual colour calibration. Cross-
White mode brightness setting of the 4
LED groups RGBW with values from
000 - 255
On Automatic locking of the controls after
approximately 1 minute of inactivity.
Display in the display after the operat-
ing test: "Locked!"
DOWN simultaneously for approx. 5
seconds
Off Automatic locking of the controls is
disabled
On Functionality is activated
Off Functionality is deactivated
Receive On/Off On = W-DMX enabled
Off = W-DMX disabled
Receive Reset No = Do not retain transmitter pairing
Yes = Retain transmitter pairing
Reset to factory settings:
ENTER -> "Reset Now!" -> ENTER
S-curve
DMX value
Main CPU Vx.x
LED Temp xx°C / xx°F
Unit °C (= display in degrees Celsius)
°F (= display in degrees Fahrenheit)
xx:xx h Displays total operating time in hours and minutes
To unlock: Press and hold UP and
11