Cameo CLZB60BLSD Bedienungsanleitung Seite 10

COLOUR MACROS (Color Macro)
15 different preset colour macros are available. Select colour macro mode as per the procedure previously described in SETTING OPERATION
MODE and confirm with ENTER. Using the UP and DOWN controls, now select the desired colour preset (observe arrow) and confirm with ENTER
(Color Off = blackout). A three-digit figure is shown on the display and you can set the desired brightness on a scale from 000 to 1000 using UP
and DOWN. Confirm by pressing ENTER. Press MODE three times to return to the main display (Colour Macro Mode).
---------------- Mode ----------------
Auto
Static
Color Macro
DEVICE SETTINGS (Settings)
Press MODE to access the device settings selection menu (--- Menu ---). Using the UP and DOWN controls, select the menu item "Settings"
(observe arrow) and confirm with ENTER.
---------------- Menu ----------------
DMX Address
Mode
Settings
This will take you to the sub-menu for configuring the following sub-menu items:
Settings
Runtime =
Display Reverse =
Display Backlight =
DMX Fail =
AC Failure =
Dimmer Curve =
10
------------ Color Macro ------------
Color Off
Red <100>
Amber <100>
Yellow Warm <100>
Yellow <100>
Green <100>
Turqoise <100>
Cyan <100>
Increase battery life by up to 24 hours with
correspondingly reduced brightness
(calculated on full with 100% battery)
Flip display
Display lighting
Operating status with DMX signal fault
Operating status with mains fault
Dimmer curve
Blue <100>
Lavender <100>
Mauve <100>
Magenta <100>
Pink <100>
Warm White <100>
White <100>
Cold White <100>
Off Function deactivated
4 hours - Configure battery run time from 4
24 hours hours to 24 hours in 1 hour incre-
ments.
On Rotate display by 180° (e.g. for over-
head installation)
Off No display rotation
On on permanently
Off Deactivation after approximately 1
minute of inactivity
Hold Last command is retained
Blackout Activates blackout
Emergency Light Lamp changes to colour macro "Cold
White"
No Action Lamp switches to battery operation in
the same operating mode
Blackout Lamp changes to blackout
Emergency Light Lamp changes to colour macro "Cold
White" with battery operation
Linear Light intensity increases linearly with
DMX value
Exponential Light intensity can be finely adjusted at
lower DMX values and broadly adjusted
at higher DMX values.
Logarithmic Light intensity can be broadly adjusted
at lower DMX values and finely adjust-
ed at higher DMX values.
S-Curve Light intensity can be finely adjusted
at lower and higher DMX values and
broadly adjusted at medium DMX
values.
Mode
Color Macro