Initial Configuration Of The Network Settings; Configuring The Network Interface - G&D DL-DVI-Vision-CAT Installation Und Bedienung

Initial configuration of the network settings

Initial configuration of the
network settings
A basic requirement to access the web application of the KVM extender is the con-
figuration of the network settings of the computer module and the user module.
NOTE:
In the default settings the following settings are preselected:
 IP address of Network interface A:
address is obtained via
 global network settings:
settings are obtained via
The required configuration settings can be made directly at the console.
IMPORTANT: At the console, you can use the
and configure the local OSD of the user module and the
+ ) to open and configure the remote OSD of the computer module.
Ctrl Num
During the starting process of the user module the settings of both hotkeys are
shown (see Starting process on page 10).

Configuring the network interface

How to configure the network interface:
1. Use the local hotkey
work interface of the user module or use the
open the remote OSD to configure the network interface of the computer module.
2. Select the entry
3. Select the entry
4. Enter the following data under
Operational
mode:
IP address:
11 · G&D DL-DVI-Vision-CAT
DHCP (fallback: IP address 192.168.0.1)
DHCP
(default: Alt + Num
and press
Network setup
and press
Interfaces
Interface A
Press F8 to select the operational mode of the interface:
switch network interface off.
 Off:
 Static: A static IP address is assigned.
IP address is obtained from a DHCP server.
 DHCP:
Enter the IP address of the interface.
The operational mode DHCP does not allow making entries.
local hotkey
) to open the local OSD to configure the net-
remote hotkey
.
Enter
.
Enter
:
(default: + ) to open
Alt Num
(default:
remote hotkey
(default: +
Ctrl Num
) to