Replacing The Wing - PARKZONE NIGHT VAPOR Bedienungsanleitung

16

Replacing the Wing

All LEDs on the wing are permanently attached. The new wing will include a new set of LEDs. To replace the
wing follow the steps below:
1. Disconnect the main LED wire from the receiver board.
2. Remove the LED that is attached to the tail of the aircraft.
Note: The LED is tack glued to the fuselage and it will be necessary to very carefully break the glue
joint loose.
3. Loosen the four screws on the wing mounting columns, and gently pull the wing off.
4. Slide the new wing back into place, and tighten the wing to the mounting columns.
5. Install the LED located near the tail, and tack glue it into place. Then, reconnect the main LED wire to
the receiver board.
Note: Use only a very small amount of hot glue or rubber cement to attach the LED to the fuselage.
Other adhesives may damage the LED.