Transmitter Specific Binding Instructions; Additional Binding Information - PARKZONE NIGHT VAPOR Bedienungsanleitung

8

Transmitter Specific Binding Instructions

MLP4DSM Transmitter
1. When you see the LED on the receiver begin to flash rapidly, push the left stick on the transmitter
inward into the case (NOT pulling down on throttle stick) until you hear it click.
2. While pushing the stick in, power on the transmitter; release the stick once the transmitter is powered
on. The transmitter will beep and the LED on the face of the transmitter will pulse.
3. Once the transmitter stops beeping it will take a second or two to connect with the airplane.
Note: It can be difficult at times to see the LED blink (indicating you are in bind mode), therefore slowly
count to five once you have connected the battery and the airplane should enter bind mode at
that time.
Binding is the process of programming the receiver of the control unit to recognize the GUID (Globally
Unique Identifier) code of a single specifi c transmitter. You need to 'bind' your chosen Spektrum™ DSM2/
DSMX technology equipped aircraft transmitter to the receiver for proper operation.
Any full range JR or Spektrum DSM2/DSMX transmitter can bind to the receiver. Please visit
www.bindnfly.com for a complete list of compatible transmitters.
NOTICE: When using a Futaba
required.

Additional Binding Information

Prior to each flight, power on your transmitter and wait for five seconds before you plug the flight battery
into the receiver. This allows time for the transmitter to scan and secure two open frequencies. If you plug
the flight battery in too quickly and miss the link, the receiver may inadvertently enter bind mode. If this
occurs leave the transmitter on, then disconnect and reconnect the flight battery.
transmitter with a Spektrum DSM module, reversing the throttle channel is
®