Replacing The Vertical Fin - PARKZONE NIGHT VAPOR Bedienungsanleitung

Replacing the Vertical Fin

To replace the vertical fin on your Night Vapor, follow the steps listed below.
1. Gently remove the clear pressure fitting tube located on the bottom of the aircraft.
2. Gently disconnect the pushrod from the control horn.
3. Slide the vertical fin out of the mounting column.
4. Reconnect the pushrod to the new vertical fin, and slide the vertical fin into the housing.
5. Slide the clear pressure fitting tube back into place.
Note: When replacing the pressure fitting tube, do not jam it against the column; this will not allow the
vertical fin to move freely throughout its range of motion.
15