Safety warning!
"Up" button (wired control point)
"Down" button (wired control point)
2. INSTALLATION
1
These instructions are mandatory for the home motorisation and automation
professional who installs the S&SO-RS100 io HYBRID drive.
1
Never drop, knock or puncture the drive or immerse it in liquid.
1
Install an individual control point for each drive.
2.1. ASSEMBLY
2.1.1. Drive preparation
Mount the accessories needed for integration of
1)
the drive into the winding tube:
Either only the wheel
Or the ring
b
Measure the length (L1) between the inside edge
2)
of the drive head and the end of the wheel.
2.1.2. Tube preparation
Cut the winding tube to the desired length
1)
depending on the product to be motorised.
Deburr the winding tube and remove all chips.
2)
For winding tubes that are smooth inside, cut a
3)
notch to the following dimensions:
= 28 mm.
e
2.1.3. Drive-tube assembly
Slide the drive into the winding tube. For
1)
winding tubes that are smooth inside, position
the cut notch on the protruding part of the ring.
Copyright © 2014 - 2015 Somfy SAS. All rights reserved.
1
Caution!
a
on the drive.
and the wheel
c
on the drive.
d
"Up" button (io-homecontrol
V
"Down" button (io-homecontrol
1)
Ø = 47 mm
2)
1)
= 4 mm;
3)
1)
Information
®
control point)
®
control point)
a
b
L1 = ...
L1
2)
d
Non contractual images.
EN
Ø > 47 mm
c
e
3