Installation: Location; Electric Connection - Storch 65 60 00 Bedienungsanleitung

Installation:
Location
The machine must not be run in rooms with a risk of fire or explosion, or positioned and operated in puddles.
Never operate the device in water.
WARNING:
Never draw in fluids containing solvents such as pain thinners, petrol, oil or similar fluids. Observer the
manufacturer's instructions on additives! The seals in the device are not solvent-resistant! The spray from
solvents is highly flammable, potentially explosive and toxic.
WARNING:
High temperatures occur in use with hot water at 60° C.
Do not touch the device without protective gloves.

Electric connection

The machine is supplied with a connecting cable with mains plug.
The plug must be be plugged into a socket that has been installed according to regulations with a 30 mA FI
residual current circuit-breaker. The socket must be secured with a 16 A fuse on the mains side.
The device possesses a voltage range which can pose an electrical hazard to humans and animals. It should only be un-
screwed and / or disassembled by authorised personnel. Similarly, maintenance and repair work should only be conducted
by electrical specialists and authorised service centres. The buyer / user operates the device at their own risk and under
their own responsibility.
When using an extension cable, this must be fitted with a circuit breaker that has been connected to the socket accor-
ding to regulations. The conductor of the extension cable must have a minimum cross-section of 2.5 mm². The plug
connection must be splash-water protected version and must not left laying on a wet floor.
WARNING:
Observe the guidelines of your water supply company. In accordance with EN 61770, the machine must not
be connected directly to the public drinking water supply.
According to DVGW (Deutscher Verband des Gas- und Wasserfaches - German Gas and Water Professional Associati-
on) a short-term connection is permissible if a backflow preventer and pipe breather are fitted in the inlet line.
It is permissible to connect the device directly to the public drinking water supply using a free run-out in line with EN
61770, Part 4; e.g. by deployment of a vessel with a floater valve.
A direct connection to a pipe network not dedicated to providing a public water supply is permissible.
High pressure hose and spraying equipment
The high pressure hose and spraying lance supplied with the machine are made of high quality material, designed for
the operating conditions of the machine and labelled in line with requirements.
If you need replacement parts, use manufacturer approved and correctly labelled parts only. High pressure
hoses and the spraying equipment must be connected to be pressure tight. Never drive over the high pressu-
re hose, pull on it excessively or twist the hose. The high pressure hose must not be pulled over sharp edges
to avoid invalidating your warranty.
44