Commissioning; Pressure Adjustment - Storch 65 60 00 Bedienungsanleitung

Commissioning

1. Connect the high pressure lance to the hand gun.
2. Unroll the high pressure hose avoiding loops and con-
nect to the hand gun. With extensions, use a high pressu-
re hose that is 20 m long or 2 x 10 m with hose connec-
tor.
Connecting the high pressure hose from the device to the
lance.

Pressure adjustment

By turning the wheel. Maximum pressure is pre-set.
3. The machine can either be connected to the pressu-
rized water line with cold water, or with water at a tem-
perature of 60°C.
When extracting outdoors, take care that the water is cle-
an.
NOTE:
Water inlet filter Art. no. 65 65 60 is used.
The hose cross-section must be at least 1/2" = 12.7 mm
(unobstructed). Strainer no. 1 must be kept clean at all
times.
4. Maximum suction height 2.5 m - See technical speci-
fications Page 2.
45