Grundig GWM 4922 SY Bedienungsanleitung Seite 31

Loading door cannot be opened.
• Door lock is activated because of the water level in the machine. >>>
running the Pump or Spin programme.
• Machine is heating up the water or it is at the spinning cycle. >>>
completes.
• Child lock is engaged. Door lock will be deactivated a couple of minutes after the
programme has come to an end. >>>
door lock.
Washing takes longer time than the one specified in the manual.
• Water pressure is low. >>>
prevent poor washing quality due to the decreased amount of water. Therefore, the washing
time extends.
• Voltage might be low. >>>
the supply voltage is low.
• Input temperature of water might be low. >>>
cold seasons. Also, washing time can be lengthened to avoid poor washing results.
• Number of rinses and/or amount of rinse water might have increased. >>>
increases the amount of rinse water when good rinsing is needed and adds an extra rinsing
step if necessary.
• Excessive foam might have occurred and automatic foam absorption system might have
been activated due to too much detergent usage. >>>
detergent.
Machine does not switch to spinning step when the laundry is not evenly distributed in the drum
C
to prevent any damage to the machine and to its surrounding environment. Laundry should be
rearranged and re-spun.
Programme time does not countdown. (On models with display)
• Timer may stop during water intake. >>>
takes in adequate amount of water. The machine will wait until there is sufficient amount
of water to avoid poor washing results due to lack of water. Timer indicator will resume
countdown after this.
• Timer may stop during heating step. >>>
reaches the selected temperature.
• Timer may stop during spinning step. >>>
might be activated due to the unbalanced distribution of the laundry in the drum.
Machine does not switch to spinning step when the laundry is not evenly distributed in the drum
C
to prevent any damage to the machine and to its surrounding environment. Laundry should be
rearranged and re-spun.
Wait for a couple of minutes for deactivation of the
Machine waits until taking in adequate amount of water to
Washing time is prolonged to avoid poor washing results when
Required time to heat up the water extends in
Timer indicator will not countdown until the machine
Timer indicator will not countdown until the machine
Automatic unbalanced load detection system
Drain the water by
Wait until the programme
Use recommended amount of
Machine
ENGLISH 31