Installation; Appropriate Installation Location; Removing Packaging Reinforcement; Removing The Transportation Locks - Grundig GWM 4922 SY Bedienungsanleitung

3

Installation

Refer to the nearest Authorised Service Agent
for installation of the product. To make the
product ready for use, review the information
in the user manual and make sure that the
electricity, tap water supply and water drainage
systems are appropriate before calling the
Authorized Service Agent. If they are not, call
a qualified technician and plumber to have any
necessary arrangements carried out.
Preparation of the location and electrical,
C
tap water and waste water installations at
the place of installation is under customer's
responsibility.
Installation and electrical connections of
B
the product must be carried out by the
Authorized Service Agent. Manufacturer
shall not be held liable for damages that
may arise from procedures carried out by
unauthorized persons.
Prior to installation, visually check if the
A
product has any defects on it. If so, do not
have it installed. Damaged products cause
risks for your safety.
Make sure that the water inlet and discharge
C
hoses as well as the power cable are not
folded, pinched or crushed while pushing
the product into its place after installation or
cleaning procedures.

Appropriate installation location

•
Place the machine on a rigid floor. Do
▪
not place it on a long pile rug or similar
surfaces.
•
▪ Total weight of the washing machine and
the dryer -with full load- when they are
placed on top of each other reaches to
approx. 180 kilograms. Place the product
on a solid and flat floor that has sufficient
load carrying capacity!
•
Do not place the product on the power
▪
cable.
•
▪ Do not install the product at places where
temperature may fall below 0ºC.
•
▪ Place the product at least 1 cm away from
the edges of other furniture.
Removing packaging
reinforcement
Tilt the machine backwards to remove
the packaging reinforcement. Remove the
packaging reinforcement by pulling the ribbon.
8 ENGLISH
Removing the transportation
locks
Do not remove the transportation
A
locks before taking out the packaging
reinforcement.
Remove the transportation safety bolts before
A
operating the washing machine, otherwise,
the product will be damaged.
. Loosen all the bolts with a suitable spanner
1
until they rotate freely (C).
. Remove transportation safety bolts by turning
2
them gently.
. Attach the plastic covers supplied in the User
3
Manual bag into the holes on the rear panel.
(P)