Herunterladen Inhalt Inhalt Diese Seite drucken

Adjusting The Feet; Electrical Connection - Grundig GWM 4922 SY Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Therefore, follow the heights described in
the figure.
To prevent flowing of dirty water back
into the machine and to allow for easy
discharge, do not immerse the hose end
into the dirty water or drive it in the drain
more than 15 cm. If it is too long, cut it
short.
The end of the hose should not be bent,
it should not be stepped on and the hose
must not be pinched between the drain and
the machine.
If the length of the hose is too short, use
it by adding an original extension hose.
Length of the hose may not be longer than
3.2 m. To avoid water leak failures, the
connection between the extension hose and
the drain hose of the product must be fitted
well with an appropriate clamp as not to
come off and leak.

Adjusting the feet

In order to ensure that the product operates
A
more silent and vibration-free, it must stand
level and balanced on its feet. Balance the
machine by adjusting the feet. Otherwise, the
product may move from its place and cause
crushing and vibration problems.
10
ENGLISH
.
Loosen the lock nuts on the feet by hand.
1
.
Adjust the feet until the product stands level
2
and balanced.
.
Tighten all lock nuts again by hand.
3
Do not use any tools to loosen the lock nuts.
A
Otherwise, they will get damaged.

Electrical connection

Connect the product to a grounded outlet
protected by a fuse complying with the values
in the "Technical specifications" table. Our
company shall not be liable for any damages
that will arise when the product is used without
grounding in accordance with the local
regulations.
Connection must comply with national
regulations.
Power cable plug must be within easy reach
after installation.
The voltage and allowed fuse or breaker
protection are specified in the "Technical
specifications" section. If the current value
of the fuse or breaker in the house is less
than 16 Amps, have a qualified electrician
install a 16 Amp fuse.
The specified voltage must be equal to your
mains voltage.

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Gwm 4901 yGwm 4901 xGwm 4922 sx

Inhaltsverzeichnis