Grundig GWM 4922 SY Bedienungsanleitung Seite 29

hose. When the container is full, block the
inlet of the hose by replacing the plug.
After the container is emptied, repeat the
above procedure to drain the water in the
machine completely.
c. When draining of water is finished, close
the end by the plug again and fix the hose
in its place.
d. Turn the pump filter to take it out.
Discharging the water when the product does
not have an emergency draining hose:
a. Place a large container in front of the filter
to catch water from the filter.
b. Loosen pump filter (anticlockwise) until
water starts to flow. Fill the flowing water
into the container you have placed in front
of the filter. Always keep a piece of cloth
handy to absorb any spilled water.
c. When the water inside the machine is
finished, take out the filter completely by
turning it.
4. Clean any residues inside the filter as well
as fibers, if any, around the pump impeller
region.
5. Install the filter.
If your product has a water jet feature, be
A
sure to fit the filter into its housing in the
pump. Never force the filter while installing
it into its housing. Seat the filter into its place
completely. Otherwise, water may leak from
the filter cap.
6. If the filter cap is composed of two pieces,
close the filter cap by pressing on the tab. If it
is one piece, seat the tabs in the lower part into
their places first, and then press the upper part
to close.
ENGLISH 29