Troubleshooting - Grundig GWM 4922 SY Bedienungsanleitung

7

Troubleshooting

Programme cannot be started or selected.
• Washing machine has switched to self protection mode due to a supply problem (line
voltage, water pressure, etc.). >>>
seconds to reset the machine to factory settings. (See "Canceling the programme")
Water in the machine.
• Some water might have remained in the product due to the quality control processes in the
production. >>>
There is water leaking from the bottom of the washing machine.
• Likely problems with hoses or the pump filter. >>>
are securely fitted. Attach the hose to the tap tightly.
• Pump filter might not be closed fully. >>>
Machine does not fill with water.
• Tap is turned off. >>>
• Water inlet hose is bent. >>>
• Water inlet filter is clogged. >>>
• The loading door is ajar. >>>
Machine does not drain water.
• Water drain hose might be clogged or twisted. >>>
• Pump filter is clogged. >>>
Machine vibrates or makes noise.
• Machine might be standing unbalanced. >>>
• A hard substance might have entered into the pump filter. >>>
• Transportation safety bolts are not removed. >>>
• Laundry quantity in the machine might be too little. >>>
• Machine might be overloaded with laundry. >>>
machine or distribute the load by hand to balance it homogenously in the machine.
• Machine might be leaning on a rigid item. >>>
anything.
Machine stopped shortly after the programme started.
• Machine might have stopped temporarily due to low voltage. >>>
when the voltage restores to the normal level.
Machine directly discharges the water it takes in.
• Draining hose might not be at adequate height. >>>
described in the operation manual.
No water can be seen in the machine during washing.
The water level is not visible from outside of the washing machine. This is not a failure.
C
30 ENGLISH
Press and hold Start / Pause / Cancel button for 3
This is not a failure; water is not harmful to the machine.
Open the inlet water taps fully.
Flatten the water inlet hose.
Clean the water inlet filter.
Close the Loading Door.
Clean the pump filter.
Be sure the seals of the water inlet hoses
Make sure that the pump filter is completely closed.
Clean or flatten the hose.
Adjust the feet to level the machine.
Remove the transportation safety bolts.
Add more laundry to the machine.
Take out some of the laundry from the
Make sure that the machine is not leaning on
Connect the water draining hose as
Clean the pump filter.
It will resume running