Peavey Invective 120 Betriebsanleitung Seite 17

PRESET FORMAT
NOTE: commands that send nibbleized preset data send HIGH byte/nibble, then LOW.
Preset Bit: 15 14 13 12 11 10
Definition: n/a gate gate effects loop 2, 1 n/a
1 = active
3
set MIDI channel default chan=1
via sysex: F0h 00h
via footswitch:
Hold the last footswitch (9/Master Boost) for 2 seconds to enter MIDI channel select mode. The LEDs on the 1-8
footswitches will blink. You can then choose MIDI channel 1-8 by pressing one of those. You can also press 9/
Master Boost again to cancel the operation.
Note: The amp will always respond to the footswitch, but the MIDI channel allows it to
selectively respond to standard MIDI messages from other devices.
9 8 7 6
CTL 4 master boost
2
00h 1Bh 16h
5 4
1 for chan 3 1 for chan 1
/ CTL 9 0 for chan 1 or 2 0 for chan 2 or 3
(n/a if bit 3 active)
don't care 0Dh
(<= 0x7F)
3 2 1 0
Overboost
ch. 3, 2, 1
channel - 1 F7h
(0-15)
17