Storing Presets - Peavey Invective 120 Betriebsanleitung

(37) Drive Boost / Preset #5
NORMAL mode: This turns Drive BOOST on and off for the current channel. When switching between chan-
nels, this will remember what the last setting was for each. The LED will be green when Drive BOOST is on.
PRESET mode: This selects Preset 5. If selected, the LED will be red.
(38) Channel Select 1 / Preset #6
NORMAL mode: This selects Channel 1. The LED will be lit GREEN. If pressed a 2nd time, the channel will
return to the previous setting. This allows quick changing between two channels using a single switch.
PRESET mode: This selects Preset 6. If selected, the LED will be red.
(39) Channel Select 2 / Preset #7
NORMAL mode: This selects Channel 2. The LED will be lit GREEN. If pressed a 2nd time, the channel will
return to the previous setting. This allows quick changing between two channels using a single switch.
PRESET mode: This selects Preset 7. If selected, the LED will be red.
(40) Channel Select 3 / Preset #8
NORMAL mode: This selects Channel 3. The LED will be lit GREEN. If pressed a 2nd time, the channel will
return to the previous setting. This allows quick changing between two channels using a single switch.
PRESET mode: This selects Preset 8. If selected, the LED will be red.
(41) Master Boost / Preset #9
NORMAL mode: This turns the Master Boost on and off. The LED will be lit green.
PRESET mode: This selects Preset 9. If selected, the LED will be red.
USING PRESET MODE
Each of the 9 presets remembers the current channel, drive boost on/off, gate on/off, CC4 on/off, effects loop on/
off and master boost on/off. Additionally, it remembers the drive boost and gate status of the inactive channels.
This way you can, for example, have a clean preset saved without drive boost, and know that when you switch to
Channel 2, drive boost will be on.
The amp comes from the factory with 9 default presets that you can modify at will. When the PRESET MODE
light is on, you can use the 9 other footswitches to recall those 9 presets. At any time you can switch to NOR-
MAL mode and make changes to that sound. This can be during a performance and not permanently stored, or
to edit a preset and store to one of the 9 settings.

STORING PRESETS

To store the current settings into one of the 9 presets, you start by holding the PRESET MODE switch down for
a second or two, after which the other LEDs will blink (except the one for the current preset which will be on
steady – a way to remind you of which preset you were working with). At this point you can press one of the 9
preset switches to store there, or press PRESET MODE again to cancel.
10