Resetting The Detailed Settings - Sony LH71-1 Anleitung

5-3-3. Resetting the Detailed Settings

Power ON
Current value display
Detailed
settings
Minimum
display
resolution
(Measuring unit
resolution)
Scaling
(1.000000)
Compensation
value
(OFF)
Flicker control
(OFF)
Sleep
(OFF)
or
Start of operation
* When the segmented error compensation value is set,
the unit switches to reference point acquisition mode.
LH71
(Lathe Function)
1
Select axis
Use and
Performed for each axis.
(Note)
Use at
2
Enter the setting value
3
Use to select the setting (compensation), and then set each option
Select axis
Enter the compensation value
Enter the
position
4
Use to select setting content
5
Use to select setting content
(When the minimum display resolution is 0.001 mm)
to select setting content
Enter the
compensation value
is displayed,
5. Settings
1 Setting at
measuring unit
resolution or
higher/Diameter
display at
measuring unit
resolution
(except for
angle)/Polarity
* The X-axis
polarity should
be set so that
the value of the
cutting direction
decreases when
using diameter
display.
2 0.100000 -
9.999999
3 OFF/LIN Err/
SEG Err
* See Part 5-5,
or
"Compensation".
4 OFF/1/2
5 OFF/1/5/10/30/
60
5-9
(E)