Sony LH71-1 Anleitung Seite 114

7. Operation Method
5
Use the key to finalize the setting.
(The value 20 is stored as the value of the machining datum
point in No. 0.)
6
Press the key.
Editing is completed, and the current value is displayed.
( lamp goes out)
* When using an edited machining datum point, carry out <Setting
of machining datum point>.
Note
ABS indication remains on during datum point mode.
The machining datum point (No. 0) is based on linear compensation.
(Position of datum point value 0 = Correction amount 0)
7-6
(E)
LH71