Sony LH71-1 Anleitung Seite 120

7. Operation Method
<Selecting a tool No.>
1
Press the key. (
2
Press the key of the third axis.
3
Enter the tool No. to be selected.
No. 1: tool master
No. 2~: tool offset
4
Use the key to finalize the setting.
The current value becomes the value of the tool offset.
In the case of the tool offset, a value resulting from the addition
of each tool offset to the tool master is displayed.
5
Press the key.
The system exits the datum point mode. (
<Switching the tool master>
When replacing the tool in position No. 1 due to wear, you can
change the master to another No.
1
Press the key. (
2
Press the key of the third axis.
3
Enter the No. to be made into the master.
4
Use the key to finalize the setting.
5
Press the key of the third axis.
The decimal point lights, and No. 5 becomes the master.
6
Replace the tool in position No. 1.
7
Set the tool offset in position No. 1.
8
Press the key for the third axis, and select No. 1.
9
Press the key for the third axis, and return the master to No. 1.
10
Press the key.
The system exits the datum point mode. (
Note
ABS indicator remains on during datum point mode.
The tool master (No. 1) is used as the basis of linear compensation.
(Position of tool master value 0 = compensation amount 0)
7-12
(E)
lamp lights up)
lamp goes out)
lamp lights up)
lamp goes out)
Display
(Example: No. 3)
Display
(Example: No. 5)
LH71