Verifying Count Values During Addition Display - Sony LH71-1 Anleitung

5. Settings

5-4. Verifying Count Values during Addition Display

For the lathe function, setting addition display (such as
of the count value shown in display 2.
1
Press the key for display 2.
2
Press the key.
" " is shown in display 2.
3
Pressing the key repeatedly cycles through the settings in the order of "
Therefore, press the
: Addition display
: Displays the measuring unit input 2
: Displays the measuring unit input 3
Addition display settings and count values that can be displayed
Settings
Notes
• When the power is turned off and on again, any switching of the display performed here will be reset, and
the display will return to the settings for "addition display" in the "basic settings".
• If a measuring unit is not connected to measuring unit input 2 and 3, or the measuring unit is not operating
properly, is shown in display 2.
5-10
(E)
key at the setting you want to display.
Count values that can be displayed
2, 3, 2+3
2, 3, 2_3
2, 3, _2+3
2, 3, _2_3
) in the "basic settings" enables switching
" t " " t " ".
LH71