Connection; Connectable Measuring Unit - Sony LH71-1 Anleitung

4. Installation and Connection of Unit

4-3. Connection

4-3-1. Connectable Measuring Unit

Model Measuring unit resolution
SJ300 Series 1 µm
GB-ER Series 0.5 µm
GB-A Series 0.5 µm
PL20B Series 10 µm
DG-B Series 0.5 µm
Adaptor (sold separately): SZ70-1
4-3-2. Connection
Be sure to provide power to the AC adaptor only after all other connections have been made.
Notes
• Fasten the connecting cables to stationary members to prevent accidental disconnection.
• Be absolutely sure to turn off the AC power to the AC adaptor of the counter unit before inserting or
removing measuring unit connector or before replacing the measuring unit. Do not plug in or unplug the
DC output connector on the counter unit side.
• Do not route connecting cables through the same duct as the machine power line.
1
Secure the counter unit to the installed bracket.
Anchor bolts (supplied): M4 x 16 (2 pcs.)
2
Secure the measuring unit.
3
Connect the measuring unit connector to the measuring unit input on the counter unit rear side.
<When using the addition function with lathe function>
Be sure to always check "Connections when using the addition function with lathe function" on
page 4-4 before making the connections.
4
Install the AC adaptor.
Note
Do not provide power to the AC adaptor in this step.
5
Remove the cable clamp on the counter unit rear side.
6
Connect the DC output connector to the DC input terminal.
7
Attach the cable of the DC output connector to the cable clamp removed in step 5, and then secure in
place.
Note
Secure while being careful not to apply force to the connector.
8
Connect the ground wire.
9
Provide power to the AC adaptor.
<When power is turned on for the first time after factory shipping>
lights up for about 2 seconds on display 1, and then
(1 or 2-axis model) is displayed.
<When the basic settings have already been completed>
is displayed on the connected displays (1 to 3).
4-2
(E)
Type of connection
Direct
Direct
Through adaptor (sold separately)
Through adaptor (sold separately)
Through adaptor (sold separately) + DZ51
(3-axis model) or
LH71