Program Function; Program Input And Editing Mode - Sony LH71-1 Anleitung

8-2. Program Function

Functions that are performed manually can be performed automatically.

8-2-1. Program Input and Editing Mode

Inputs and edits the program.
1
Press the key. (
2
Press the key. (EDIT lamp flashes)
3
Press the key corresponding to the axis to be set.
4
Enter the displacement using the numeric key, and press
the key to finalize the input.
5
Press the key.
After the next step No. is displayed, you can enter the displacement.
6
Press the key corresponding to the axis to be set.
7
Enter the displacement of the next step using the numeric key,
and press the key to finalize the input.
8
Press the key.
After the next step No. is displayed, you can enter the displacement.
Repeat steps 7 and 8, and enter the displacement for all steps.
(max 150 steps for each axis)
9
After entering the displacement as far as the final step, press
the key.
is displayed, and the entered program is
finalized.
10
Press the key.
The next step No. is displayed.
11
Press the key. The system exits the program mode.
The current value is displayed.
* To end machining before completion, press the
value for that position is displayed. To perform machining again, start from step 1.
LH71
lamp lights up)
key.
Display
(Current value
display)
r
(Example:
10.000)
r
(Example:
20.000)
r
is displayed, and then the incremental
8. Applied Functions
8-7
(E)