Line Hole Function - Sony LH71-1 Anleitung

8. Applied Functions

8-1-2. Line Hole Function

Equidistant holes can be opened along a designated straight line. This function is available for 2-axis and
3-axis models only.
Parameter input
1
Press the key so that LINE flashes, and then press the
2
Enter the angle
3
Enter the number of holes
4
Enter the hole interval
(mm (inch)) and minimum input resolution.
Execution
1
Move to the start position, and then press the
Position of No. 1 hole
• "0" which indicates (the starting position) is displayed.
• When you press the
• Move the machine to display "0".
• When the machine moves to the final hole position and you press the
operation is completed.
8-4
(E)
, and press the key. Input range: 0.00 to 359.99 degrees
, and then press the
, and press the
Number of holes
Start position
key to execute.
key, the next hole position (No. 2) is displayed.
key (LINE lights up).
key. Input range: 2 to 360 holes
key. Make the entry based on the input units
Hole interval
Angle
key, " " is displayed and
LH71