Sony LH71-1 Anleitung Seite 104

5. Settings
Entering the segmented error compensation value
The entry procedure when resetting the "detailed settings" (see Parts 5-2-3 and 5-3-3) is shown below.
1
Press the key when the current value is displayed.
2
Use the key to display
3
Press the key to display
4
Press the key.
5
Press the key for the axis where the compensation
value will be input.
Enter the input points and compensation amount below.
Enter the input points starting from the smallest number.
6
Use the numeric keys to enter input point 1.
Note
The reference point position of the measuring unit becomes 0.
To enter a value on the negative count side form the reference
point, enter a negative value.
7
Press the key.
8
Use the numeric keys to enter the compensation amount.
9
Press the key.
10
Repeat steps 6 to 9 until all the input points and
compensation amount are entered.
11
Press the key.
The number of input points are displayed as "
12
<To continue and enter other display compensation amount>
Perform the procedure starting from step 5.
<To exit>
Press the key.
The unit automatically switches to reference point acquisition mode, and so obtain the reference point
(see the next page).
5-16
(E)
.
.
".
Display
r
(Example: L =
200.000)
(Example:
ε
x = –0.005)
r
r
LH71