Collecting Anti-Freeze; Connecting The Water Supply; Control / Operation; Switching On The Device - Storch 140 HOT Bedienungsanleitung

3.6 Connecting the water supply

In the case of poor water quality (sand, etc.), we recom-
mend that a fine water filter is fitted in the water inlet.
We recommend the use of a textilereinforced water hose
with a nominal diameter of min. 3/4" (19 mm).

Control / Operation

4.1 Switching on the cleaner
1.
Move the main switch into position ‚Cold Water' (A) The
control electronics system performs a self-test, all the
LEDs light up once. The motor starts.
lights up..
2.
Ventilate the machine by activating the spray gun
3.
When the water flow is even, continue with the following
steps
Original instruction
1.
Rinse the water supply hose briefly in order to prevent
sand an other dirt particles entering into the machine.
2.
Connect water supply hose to the machine.
3.
Open water tap. See chapter Technical Data for required
quantity of water and water pressure.
3.8 Antifreeze - before first use
The machine is protected with anti-freeze from the fac-
tory. Catch the liquid discharging at first (approx. 5 l) for
re-use in a container

4.2 Connections

4.2.1 Connecting the spray lance to the spray gun

NOTE!
Always remove any dirt from the nipple before connecting
the spray lance to the spray gun.
1.
Pull the blue quick-release grip (A) of the spray gun back-
wards.
2.
Insert the nipple of the spray lance (B) into the quickrelea-
se connection and release it.
3.
Pull the spray lance (or other accessory) forwards to check
that it is securely attached to the spray gun.
96