Other Faults; Recycling The Cleaner; Additional Faults; Recycling The Device - Storch 140 HOT Bedienungsanleitung

8.2 Other Faults

Faults
not ON
Pressure too low
Device not running smoo-
thly
No detergent drawn in
Burner soots up

9.1 Recycling the cleaner

If the cleaner is discarded, make it unusable immediately
1.
Unplug the cleaner and cut the power cord. The cleaner contains valuable materials that should be
recycled. Therefore, make use of your local waste disposal site. Contact your local authorities or your
nearest dealer for further information.
Cause
Plug not connected to the electrical plug
socket
High pressure nozzle worn out
High-pressure pump draws in air from an
empty cleaning agent tank
Detergent tank empty
Dirt in detergent tank
Suction valve at cleaning agent inlet soiled
fuel contamination
Burner sooted or adjustment
incorrect
Remedy
Put the plug into the electrical socket
Check fuse (see chapter Technical Data)
Replace nozzle
Close the cleaning agent metering valve.
Remove the spray pipe from the spray
gun. Activate the spray gun and allow the
device to run until the air has escaped from
the system and the pump once again runs
smoothly.
Top up detergent tank
Clean detergent tank
Remove suction valve and clean or replace
Contact STORCH Service
103 Original instruction