BENE TWIN TABLE Sicherheitshinweise Und Bedienungsanleitung Seite 6

SICHERHEITSHINWEISE
SAFETY INSTRUCTIONS
CONSIGNES DE SÉCURITÉ
11. Never open the enclosure of the control unit or power
supply. Unauthorised opening of the enclosure or impro-
per repairs may endanger the user and voids all warranty
claims.
12. Only professionals authorised by the manufacturer may do
maintenance or repair.
13. Do not operate devices in explosive environments.
14. This furniture is admitted only for the commercial office
area and management in interiors.
15. This appliance must not be used by any person (including
children) with limited physical, sensorial or mental abili-
ties or failing experience and/or knowledge unless they are
supervised by a person responsible for their safety or recei-
ved instructions about how to use the appliance. Children
should be supervised in order to make sure that they do
not play with the appliance.
16. The manufacturer assumes no liability for damage resul-
ting from improper use.
17. Connection plug boards must be fixed properly for easy
plugging and unplugging. Plugs and connection plug
boards must be located in such a way that no fluids come
into contact with electrical equipment when the office fur-
niture is used properly.
18. The power cable must be secured in the strain relief.
Interconnecting cables may be run loosely. All lines and
cables must be run in such a manner as to avoid mechani-
cal damage (i.e., shearing, abrasion...).
19. Furniture with flexible or height-adjustable components
require special care. Cables must be sufficiently long to
allow height adjustments without damaging the cables and
wiring (i.e., stretching, crushing, ...).
20. If the power cord of this equipment is damaged, it must
be replaced by the manufacturer, their customer service,
or a similarly qualified person so as to avoid any risk.
21. Do not spill liquids into the control unit or power supply
unit, as this could cause electrical shock or short circuits.
22. The operation of the control mechanism and the power
supply unit requires a minimum of 5°C and a maximum
temperature of 40°C.
6