Operating The Machine In System Management Mode - Canon imageRUNNER C1028i Handbuch

Operating the Machine in System Management Mode

The System Manager log-in procedure varies depending on the applied
authentication modes provided by the uniFLOW integration. See the table below.
NOTE
The System Manager refers to the user who can access the System Settings of the
machine.
Authentication Mode
(p. EN-3)
Authentication to the
Machine
Authentication to the Login
and Document Release
NOTE
• You can give a user System Manager privileges by the procedures below (The
procedures and the privileges are applicable only when "Authentication to the
Machine" is applied.). For more information, see the documentation included with the
uniFLOW software.
- For the user ID and password/PIN code/ID card, select the user type as the System
Manager when you register the user in the uniFLOW server.
- For the department ID and password, assign the System Manager ID and System
Password registered in the machine to the user when you register in the uniFLOW
server.
• When you log in to the machine as an end user in "Authentication to the Machine
mode", you cannot access the System Settings of the machine and the message
<Only users logged in as an administrator can access the selected settings.> appears.
To access the System Settings, once log out of the machine and again log in as the
System Manager.
Description
Log in to the machine with the user ID and password, PIN
code, ID card, or department ID and password for the
System Manager. Otherwise log-in procedures are similar to
those for end users. (See "Logging in to the Machine," on
p. EN-8.)
Enter the System Manager ID and System Password
registered in the machine when you access the System
Settings of the machine. When they are not set, any user can
log in to the machine as the System Manager and can
access the System Settings.
Managing the Machine with the uniFLOW Integration
EN-6