Canon imageRUNNER C1028i Handbuch Seite 14

Resetting the IP Address of the Machine
If the message <Being set... Please wait. If the screen does not turn off after a
while, contact the System Manager.> persists on the display after the machine is
turned ON, the IP address of the machine may not be properly set. Resume
communications between the machine and the uniFLOW server by resetting the IP
address of the machine as described below.
1
Press the right Any key to select <Sys. Mgt. Set.>.
2
Enter the System Manager ID and System Password using
(numeric keys).
❑
Use [ ], [ ], or
[OK] ➞ enter the System Manager ID.
❑
Use [ ], [ ], or
[OK] ➞ enter the System Password.
NOTE
The System Manager ID and System Password are both set to '7654321' as default.
3
Press
4
Check the IP address of the machine and set it on <Network
Settings>.
NOTE
Set the IP address of the machine depending on the network environment you are
using.
5
Restart the machine.
Turn OFF the machine and wait at least 10 seconds before turning it ON again.
EN-7
Managing the Machine with the uniFLOW Integration
(Scroll Wheel) to select <System Mgmt. Dept. ID:> ➞ press
(Scroll Wheel) to select <System Management PW:> ➞ press
(Log In/Out) on the machine's control panel.
-